Agilent Technologies N2792A, Руководство пользователя

Страница: 29 / 36

29
11 Enable the output of the calibrator.
12 Record the DC amplitude of the square wave and divide 10 into just the
amplitude of the oscilloscope. Verify that the probe gain accuracy is ±2% +
scope gain accuracy. Record the test results as DC Differential Gain
Accuracy in
Table 9 on page 30 .
13
Disable the 9500B’s output.
14
Connect the 50
Ω
BNC feed through adapter to the N9500B’s
CH1
active
head.
15
Attach the BNC (f)- to- banana post adapter to the BNC feed through
adapter.
16
Attach the differential probe input leads by clipping the alligator clamp to
the BNC adapter banana post.
17 Enable the 9500B’s output.
18 Configure the oscilloscope to the following settings:
Amplitude Scale (Channel 1): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mV/div
Time Scale:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 ns/div
Acquisition mode: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Peak Detect
19 Center the trace on the oscilloscope.
20
On the N9500B, configure
CH1
to to the following settings:
Waveform: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . sine wave
Load: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .50Ω
Amplitude: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3V pk-pk
Frequency: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 MHz
21
Measure the peak- to- peak amplitude on the oscilloscope. It should be
greater than or equal to 210 mV – scope vertical accuracy. Record the test
results as Bandwidth in
Table 9 on page 30 .
22
Disable the N9500B’s output and disconnect the probe input.