Agilent Technologies IDP-15, Инструкция по эксплуатации

Страница: 16 / 54

IDP-15 Dry Scroll Vacuum Pump
DRAFT 12/21/17
16
Unpacking and Inspection
Preparation for Installation
The pump is supplied in a special protective packing. If this shows signs of damage,
which may have occurred during transport, contact your local sales office.
Total weight of the packing, IDP-15 pump included, is approximately 54 kg (118 lbs).
WARNING
When unpacking the pump, be sure not to drop it and avoid
any kind of sudden impact or shock vibration to it.
NOTE
Normal exposure to the environment cannot damage the
pump. Nevertheless, it is advisable to keep the pump inlet
closed until the pump is installed in the system.
CAUTION
Before operating the IDP-15 disengage the shipping locks.
1. Orient the shipping container with This End Up on top.
2. Open the box, remove the foam block and carefully lift the IDP-15 out of the box.
Attach a hoist capable of lifting 250 pounds onto the eyebolt on the top of the pump.
Remove the plywood base.
3. Save the carton and all packing materials.
4. Inspect the pump for damage. If there is shipping damage, contact the freight carrier
and your local Agilent sales office immediately.
5. Loosen the two front and two rear cowling screws and slide the L-brackets up.
Retighten the cowling screws. The pump now rests on its rubber feet.