Agilent Technologies ESA E4401B Скачать руководство пользователя страница 9

Страница: 9 / 10

Installation Note E4411-90051

13. Refer to Figure 4. Remove the IF bracket by removing four screws (3). This bracket is located in

back of the aluminum protrusion at (4). Discard the bracket.

14. Carefully insert the tracking generator assembly (2) into the motherboard.

15. Insert and attach the four screws (1) that secure the tracking generator to the chassis. These screws

are supplied in this kit. Torque these screws to 101 N-cm (9 in-lb.).

Figure 4. Remove the IF Bracket and Install the Tracking Generator

Replace Front Frame

16. Make sure the water seal is still in place around the output connector hole on the front panel

assembly.

17. Carefully slide the front frame onto the chassis and attach the ribbon cable to connector A2 on the

front panel keyboard printed circuit board. Make sure that the ribbon cable is not
pinched between assemblies.

18. Refer to Figure 3 and replace the four screws that secure the front frame to the chassis at locations

(1), (2) and (3). Torque these screws to 9 in-lb (101 N-cm).

Содержание ESA E4401B

Страница 1: ...rinted in USA December 1999 Supersedes P N E4411 90020 Installation Note Agilent Technologies ESA E4401B E4411A E4411B Spectrum Analyzers 1 5 GHz Tracking Generator Retrofit Kit 50 Ω Retrofit Kit Option 1DN 75 Ω Retrofit Kit Option 1DQ ...

Страница 2: ...ard to this material including but not limited to the implied warranties of merchantability and fitness for a particular purpose Agilent Technologies shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing performance or use of this material Copyright Agilent Technologies 1999 ...

Страница 6: ...ly put the analyzer on the work surface with the front frame 2 and 3 facing down 3 Position the handle 4 as shown in the figure 4 Remove the four screws 5 that hold the rear frame 6 and outer cover 7 in place 5 Lift the instrument rear frame 6 and outer cover 7 up and off of the instrument and set them aside Figure 1 Remove Rear Frame and Outer Cover ...

Страница 7: ...tion Note E4411 90051 7 Remove Chassis Cover 6 Refer to Figure 2 Remove the screws 2 and 3 attaching the chassis cover 1 to the chassis 7 Remove the chassis cover from the chassis Figure 2 Remove Chassis Cover ...