Agilent Technologies E8401A, Руководство пользователя и обслуживания, Страница: 35 / 66

Rack Mounting and Option Installation 33 Chapter 2
10.Slide the rack slide intermediate sections out from the rack slide
stationary sections until they lock into place. With one person on each
side, lift the mainframe and slide the chassis sections into the
intermediate sections until the chassis sections lock into place. Slide
the mainframe into the rack until the rack mount adapter flanges are
against the rack’s vertical rails. Secure the mainframe to the rack
using the adapter dress screws.
WARNING
To prevent injury during rack mounting, the mainframe should
be empty and two people should lift the mainframe into the
rack.
Installing the Cable Tray
The Agilent E840xA Cable Tray (Option 914) allows you to route VXI
instrument cables and wires under the mainframe. The cable tray can be used
when the mainframe is on a bench top or when mounted in a standard EIA
cabinet. The tray is compatible with the support rail (Agilent E3664A) and
rack slide (Agilent p/n 1494-0411) kits.
Note
If you ordered the support rail (Agilent E3664A) or rack slide (p/n
1494-0411) kit, install the cable tray before rack mounting the mainframe.
Parts List
The parts included in Option 914 are shown in Table 2-3.
Procedure
1. Remove the four mainframe feet by lifting the tabs and moving each
foot towards the center of the mainframe.
2. Attach the cable tray to the mainframe as shown in Figure 2-11 using
four m5x8 pan head screws. Select the tray holes based on the amount
of cable clearance required.
The bottom mounting holes position the tray over one additional EIA
rack unit (44.5 mm), the top holes position the tray over two EIA rack
units, and the center holes position the tray between one and two EIA
rack units.
Table 2-3. Agilent E840xA Cable Tray Option 914 Parts List.
Quantity Description Part Number
1 Cable Tray E8400-04102
4 Cable Tray-to-Mainframe Screws -
m5x8 pan head 0515-0979