Agilent Technologies E364XA Series, Руководство пользователя

Страница: 85 / 220

Chapter 4 Remote Interface Reference
Output Setting and Operation Commands
84
INSTrument:COUPle[:TRIGger]?
Query the output coupling state of the power supply. The returned value is ‘‘0’’
(OFF) or ‘‘1’’ (ON).
MEASure:CURRent?
Query the current measured across the current sense resistor inside the power
supply.
MEASure[:VOLTage]?
Query the voltage measured at the sense terminals of the power supply.
OUTPut:TRACk[:STATe] {ON | OFF}
Enable or disable the power supply to operate in the track mode. See “Tracking
Operation” on page 44 for more information on tracking operation. At
*RST
,
the track mode is disabled.
OUTPut:TRACk[:STATe]?
Query the tracking mode state of the power supply. The returned value is ‘‘0’’
(OFF) or ‘‘1’’ (ON).
VOLTage {
<voltage>
| MINimum | MAXimum | UP | DOWN}
Program the immediate voltage level of the power supply. The immediate level
is the voltage value of the output terminals.
The
VOLTage
command changes the output of the power supply to the newly
programmed value regardless of the output range presently selected.
This command also increases or decreases the immediate voltage level using
the ‘‘
UP
’’ or ‘‘
DOWN
’’ parameter by a predetermined amount. The command
VOLTage:STEP
sets the amount of increase or decrease. Notice that a new
increment setting will cause an execution error -222 (Data out of range) when
the maximum or the minimum rated voltage is exceeded.
VOLTage? [MINimum | MAXimum]
Query the presently programmed voltage level of the power supply.