Chapter 1
Installing Memory into an Agilent
E1300B/E1301B Mainframe
Description
You can install one or two memory modules onto the controller circuit board in the Agilent E1300B/E1301B
Mainframe. Any combination of the 512kByte and 1MByte modules can be used to produce 512 k, 1 M, 1.5M
or 2M of nonvolatile memory. The new memory will be used instead of (not in addition to) the standard 64k of
built-in controller board memory.
Warnings and Cautions
WARNING
SHOCK HAZARD. Only service-trained personnel who are aware of the hazards
involved should install, remove, or configure the system. Before you perform any
procedures in this guide, disconnect AC power and field wiring from the mainframe.
Caution
Do not install or remove modules with power applied to the mainframe. Doing so may
damage the modules and the mainframe.
Caution
STATIC ELECTRICITY. Static electricity is a major cause of component failure. To
prevent damage to the electrical components in the mainframe, plug-in modules, and
memory modules, observe anti-static techniques whenever handling any of this
equipment.
Installation Kit
The following items comprise the memory module installation kit:
•
#10 Torx®* Key - 1 each
•
#10 Torx® screws - 4 each
•
Nonvolatile Memory Module - 1 each
* Torx is a registered trademark of the Camcar Division of Textron Inc.
Installing Memory into an Agilent E1300B/E1301B Mainframe 1-1
Содержание E1300B
Страница 2: ......