Agilent Technologies DS40M, Руководство пользователя

Страница: 85 / 112

Technical Information
Transport and Installation
5
DS40M Pump User Manual / 87-900-147-01(B) 85/112
Transport and Installation
The pumps are shipped to the customer inside cardboard boxes.
Total weight of the pack, including the pump, is about 13 kg
.
The case must be handled with care, using appropriate lifting
equipment.
CAUTION!
When moving the case, ensure that it is securely bound to the lifting equipment
and that the equipment is strong enough to support the weight.
The pump working environment is a traditional industrial
environment. Naturally sites with corrosive vapors or excessive heat
are best avoided.
Room temperature should ideally be between 12 °C and 40 °C. If the
temperature is not inside this range, consult Agilent technical service
for the changes required.
Setting the pump in position should be performed as follows:

Pump laid on the ground. There are no special instructions for
this type of installation, except that the floor should be as flat as
possible and suited to bear the weight of the pump (it should
ideally be a concrete floor) and of any accessories mounted on it.
Note that the pump is stable on its base plate and it should not be
necessary to anchor it to the floor with bolts and screws; also
vibrations to and from the pump are greatly reduced by the use
of rubber feet.

Pump off the ground. In this case, the user must design a suitable
support structure, remembering the following points:

the plane supporting the pump must be perfectly horizontal;

the structure should be adequately rigid;

the relevant safety precautions should be applied.