AGFEO AS 100 IT, Руководство пользователя

Страница: 159 / 204

3 - 5
Programming your
System
ST 25 DECT 30 ST 30
Programming with the
S
procedure always covers the steps:
Start programming mode, input and exit programming mode.
When programming, pay attention to the dial tones or dial pulses in the handset. Wait after
enter- ing every digit until the digit has been dialed. Only then will you hear the
acknowledge tone if your entry is valid or the error tone if your entry is invalid.
Recommendation: Use a DTMF telephone (touch-tone dialing) for faster programming.
You can press the loudspeaker button instead of „Lift handset“ or „Replace handset“ when
programming on the system telephone.
Starting the programming mode
To be able to change settings you must
first start the programming mode
Lift handset
Start programming mode
acknowledge tone or enter setup code
Replace handset
Enter setup code?
If you hear the acknowledge tone after
S705
, no setup code is
programmed in the telephone system. It
is not necessary to enter the setup code.
If you hear the error tone, the last input is
wrong. Start the input again from the
beginning. If you do not hear any tone
after
S705
, a setup code is
programmed in the telephone system.
Enter the setup code in 4 digits. If the
code is correct, you will hear the
acknowledge tone. If the code is wrong,
you will hear the error tone. Replace the
handset and start the whole input again
from the beginning with the correct setup
code.
h
S705
Q
ª
Notes on programming with
S
-
procedures
Exiting the programming mode
After you have made all the settings, you
exit the programming mode. At the same
time you save the new settings. These are
retained even in the event of a power
failure.
Lifthandset
Exit the programming mode
Acknowledge tone
Replace handset
h
S700
Q
ª
3 - 5