AGCO Glencoe SS7600 Series, Руководство оператора

Страница: 38 / 51

3-11 DECALS
Decals are provided for your safety and for
machine identification. Be sure to keep safety de-
cals legible and clean. The following decals must
be installed before transporting your machine:
3-11.1 Install red and amber reflector decals on
outermost parts of the disc frames (See Fig-
ure 3-13). Red decals go on the rear disc
frames only. They must face traffic coming
from behind the machine.
3-11.2 Amber decals must go on the left disc
gang frames facing on-coming traffic.
IMPORTANT
DECALS CAN BE REPLACED IF NECESSARY
THROUGH THE PARTS DISTRIBUTION CENTER
OR YOUR DEALERSHIP.
3-12 WARNING LIGHTS INSTALLATION
3-12.1 Assemble lights to the light bracket using
1/4 X 1-3/4 capscrews and nuts. Insure the
wires are in the groove in the base of the
light toward the mounting surface of the
bracket. Assemble one light for left side and
one for right side. The red light should be to
the rear with the amber light being the outer
most light.
3-12.2 Install the assembled lights on the outside
of the frame just forward of the rear disc ad-
just plates. (See Figure 3-13).
IMPORTANT
MAKE SURE LIGHTS ARE POSITIONED FOR
MAXIMUM VISIBILITY FROM THE REAR.
3-12.3 Install the rear wiring harness between the
lights.
3-12.4 Assemble the harness extension to the
center plug on the rear harness.
3-12.5 Install the main harness by starting at the
hitch and routing the harness through the
hose loops to the extension harness. See
wiring diagram as shown in Figure 3-14.
3-12.6 Insure the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
3-13 LUBRICATION
The Soil Saver must be lubricated before using
it for the first time, and at regular intervals thereaf-
ter. Use a standard multi-purpose grease. ( See
Section 4-6) to lubricate your Soil Saver.
3-21
Figure 3-14 Wiring Diagram