AGCO Glencoe SS7600 Series, Руководство оператора

Страница: 28 / 51

3-6 TANDEM AXLE MODEL HYDRAULIC PLUMBING INSTALLATION
IMPORTANT
1. Pipe sealant is not required to install hoses
to manifold and cylinders equipped with hy-
draulic O-ring fittings.
2. In the following procedure, left- and right-
hand are determined standing at the back of
the machine, looking towards the front.
3. In the steps below, refer to Table 3-2 for
hose part numbers and to Figure 3-7 to insure
proper location of each hose during installa-
tion.
4. Owner of tractor is required to supply some
of the parts in this procedure for its proper
completion. Please read through this procedure
before installing hoses.
3-6.1 Install the hydraulic manifold on the frame
and secure with 1/2" x 3-1/2" cap screws and
locking nuts. The manifold mount is at the
center of the frame above the rockshaft (See
Figure 3-4) .
3-6.2 Install a 90° o-ring elbow in the bottom
rear port and a 90° elbow and a straight
adapter in the top rear port of the hydraulic
manifold.
3-6.3 Install a 90° restrictor o-ring fitting to the
base end of all four cylinders.
3-6.4 Install a 90° unrestricted o-ring fitting to the
rod end of all four cylinders.
3-6.5 Install a No. 2 hose to the base port of the
right-hand disc adjust cylinder and to the
top-right port of the hydraulic manifold.
3-6.6 Install a No. 3 hose to the rod port of the
right-hand disc adjust cylinder and to the
second port down on the right side of the hy-
draulic manifold.
3-6.7 Install a No. 2 hose to the rod port of the
right-hand gauge wheel cylinder and to the
lower port on the right side of the hydraulic
manifold.
3-6.8 Install a No. 3 hose to the base end of the
right-hand gauge wheel cylinder and the third
port down on the right side of the hydraulic
manifold.
3-6.9 Install No. 2 hose to the base end of the
left-hand disc adjust cylinder and the top el-
bow on the left side of the hydraulic mani-
fold.
3-6.10 Install No. 3 hose to the rod end of the
left-hand disc adjust cylinder and the bottom
elbow on the left side of the hydraulic mani-
fold.
3-6.11 Install No. 4 hose to the rod end of the
left-hand gauge wheel cylinder and the bot-
tom elbow on the rear of the hydraulic mani-
fold.
3-6.12 Install No. 5 hose to the base end of the
left-hand gauge wheel cylinder and the top
elbow on the rear of the hydraulic manifold.
3-6.13 Install No. 1 coupling hoses to the appro-
priate ports in the front of the hydraulic mani-
fold (couplers for the 1/2" coupling hoses on
theee tractor end must be supplied by the
owner to match the tractor).
CAUTION
IMPROPER RESTRAINT OF CYLINDER
HOSES CAN CAUSE THEM TO GET
TANGLED IN THE MACHINE DURING
OPERATION.
3-6.14 Secure all cylinder hoses to the frame,
with the plastic tie wraps, to eliminate slack
and/or rubbing that could cause damage or
interference.
3-11