AGCO Glencoe FC3800 Series, Руководство оператора

Страница: 52 / 62

4-4.3 Set the unit work ing depth.
a. To ad just the depth, lower unit to the ground
and com pletely re tract the lift cyl in ders.
b. Screw the ad just ment rod in to de crease the
work ing depth, out to in crease the work ing
depth.
(See Fig ure 4-2).
IM POR TANT
IT MAY BE NEC ES SARY TO RAISE THE UNIT
SLIGHTLY OFF THE DEPTH AD JUST MENT
SCREWS IN OR DER TO TURN THEM.
4-4.4
Check the front to rear lev el ing of the
frame. Ad just ra dius rod un til frame is level
at work ing depth and lock it with the jam nut.
IM POR TANT
WITH TRACK TYPE TRAC TORS, THE TRAC TOR
DRAW BAR MAY NEED TO SWING. CHECK
YOUR TRAC TOR OP ERA TOR’S MAN UAL FOR
REC OM MENDED SET TINGS.
IM POR TANT
IT MAY BE NEC ES SARY TO AD JUST THE
WINGS DIF FER ENT THAN THE MAIN FRAME
FOR THE UNIT TO OP ER ATE LEVEL.
IM POR TANT
ALL WINGS SHOULD BE AD JUSTED TO SAME
DEPTH TO PRE VENT THE MA CHINE FROM
PULL ING TO SIDE (See Fig ure 4-3).
4-4.5
Al ways lift the Field Cul ti va tor com pletely
out of the ground be fore turn ing or back ing.
This pre vents shank dam age or dam age to
their re spec tive mount ing brack ets.
4-4.6 Re duce speed at field ends, and lift the
Field Cul ti va tor com pletely out of the ground
be fore turn ing.
4-4.7 Af ter a few hours of op era tion, check all
bolts for tight ness, es pe cially the shank U-
bolts and pivot bolts. Tighten wheel lug bolts
to 90 ft- lbs of torque. Tighten any loose bolts
to the torques shown in
Ta ble 2 -1 .
4-3
Fig ure 4-1 Wing Trans port Locks
Fig ure 4-2 Ad just ing Unit Work ing Depth
Fig ure 4-3 Ad just ing Wing Work ing Depth