Agatec SmartRod, Руководство пользователя

Страница: 5 / 33

5 4
15. Units of Measure
Press & simultaneously to change the current settings on the LCD.
The units selected are shown in the bottom right corner (m, ft, or inches).
Continue pressing to scroll through the choices: meters, cm, mm / feet,
10ths, 100ths / feet, inches, 16ths.
• LCD
Overview
Inside front cover has photos corresponding to these callouts.
• Front View
1. Bubble vial: To plumb SmartRod for accurate readings.
2. LCD: Measurements, mode, settings, status.
3. Control panel: Power, units, mode, and volume buttons.
4. Beeper output: First short beep indicates reception.
Second double-beep indicates measurement.
5. Screws: To loosen or tighten each extendable element.
6. Lower telescoping element: Extend first so control panel
is at eye level. Twist left to unlock, extend, and twist right to lock.
7. Rubber bumper: Protects reception window if dropped.
8. Receiver battery compartment: To insert 3 AA batteries,
open door and follow polarity indications inside.
• Rear View
9. Reception window : Must be directed toward laser.
10. Control panel battery compartment : To insert 3 AA batteries,
slide cover up and note the polarity indications inside.
11. Serial number / ID label
• Keypad Functions
12. Power
• Press to turn power ON. Press and hold for 2 seconds to turn power OFF.
• Press to take a measurement.
13. Beeper volume
Press to cycle through: High, Normal and Off. One beep is emitted at
the selected volume when changed.
Note: When sound is Off, no single beep will signal that a
laser beam has been detected.
14. SET
• Press once for the Cut & Fill Mode. The last measurement taken (reference
point) will move to the top. On the next measurement, the difference to the
reference measurement is displayed as the Cut or Fill value.
• Press and hold for Measuring Tape Mode (not using the laser beam).
1
8
9 10
2
3 4
5
6
7
1. Elevation or measurement
2. Units of measurement
3. Elevation in fractions of an inch
4. Up or down arrows: cut or fill indicators
5. Battery status for laser receiver (shows full)
6. Battery status for control panel (shows nearly depleted)
7. Beeper volume control
8. Tape measure mode indication
9. Elevation mode indication
10. C or F: Cut or Fill indicator (with ft. unit settings)
SmartRod-16june.qxp 28/06/09 14:45 Page 4