AGA Little Wenlock Classic, Инструкция по установке и эксплуатации

Страница: 12 / 16

Before lighting the stove check with the installer that the installation work
and commissioning checks described in the installation instructions have
been carried out correctly and that the chimney has been swept clean, is
sound and free from any obstructions. As part of the stoves commission-
ing and handover the installer should demonstrate how to operate the
stove correctly.
LIGHTING
IMPORTANT: The first few fires should be relatively small to permit the
refractory to set properly and to season the stove.
1. Before lighting the stove, ensure that any build-up in the firebox has been
removed and that the ashpan has been emptied.
2. Open the spin valve by turning it anti-clockwise. Open secondary air control
by pulling it fully out. These parts will become hot. Use the tool provided.
3. Lay a few crumpled sheets of paper on the grate and then a few small sticks,
kindling or an approved firelighter.
4. Ignite and close the door.
5. Never use inflammable liquid i.e. gasoline, petrol paraffin etc. to start or
freshen up a fire in this heater.
6. When the fire is well established add fuel to the firebox. Adjust to the desired
setting the spin valve and / or the secondary air slide depending on the fuel
burned. (See Re-Fuelling Section).
7. To shut the fire down, do not add fuel. Make sure that the fire door is
properly closed, that the spin valve is firmly shut and the secondary air
slide is pushed in. Cutting off the air supply will reduce the heat output.
11