TROUBLESHOOTING YOUR BEVERAGE CENTER
Problem
Possible Cause
Remedy
Unit not cold enough
Adjust temperatures (See “Set Tempera
-
tures” on page 6)
• Control set too warm
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours.
• Airflow must not be obstructed to
front grille. See “clearances” on
page 4.
• Check door alignment and/or replace
door gasket.
Unit too cold
Adjust temperatures (See “Set Tempera
-
tures” on page 6)
• Control set too cold
• Door gasket not sealing properly.
• Adjust temperature warmer. (See
page 6, “set temperature”). Allow 24
hours for temperature to stabilize.
• Check door alignment and/or replace
door gasket.
No interior light.
• Failed light bulb
• Replace light bulb, see page 16.
Light will not go out when door is closed
• Door not activating light switch.
• Display light is turned on.
• Unit not level, level unit, (See page 4,
“leveling legs”)
• Verify the door is aligned properly,
refer to page 10 for instructions.
• Turn off display light, shut door.
Noise or Vibration
• Unit not level
• Level unit, see “Leveling Legs” on
page 4.
Unit will not run.
• Unit turned off
• Power cord not plugged in.
• No power at outlet.
• Turn unit on. See “Starting your appli
-
ance” on page 6.
• Plug in power cord.
• Check house circuit.
Before you call for service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualified service technician.
Electrocution Hazard
- Never attempt to repair or perform
maintenance on the unit until the main electrical power has
been disconnected. Turning the units control “off” does not
remove electrical power from the units wiring.
17
