AGA marvel 3BARM, Инструкции по установке, эксплуатации и обслуживанию

Страница: 13 / 48

NOTE
NOTE
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
13
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet prior
to fabricating the custom panel. Failure to do so may result in
mis-alignment of the custom panel with the hinge bracket. The
door should be parallel to the sides and top of the refrigerator.
If alignment is necessary the door may be adjusted by loosen-
ing the 2 screws which secure the top and/or bottom hinge
adapter brackets, located on the top and bottom of the door
and adjusting the door side to side. Use a 5/32” allen wrench, for
this procedure. (See Figure 6 below). When finished aligning the
door, tighten the screws securely.
For overlay with lock option panel thickness to be 3/4” (19mm)
maximum to 5/8” (16mm) minimum.
Weight of the overlay panel should not exceed 20 pounds (9.1
kilograms).
For the door to close properly, it is necessary to maintain a mini-
mum space of 9/32” (7mm) between the door and cabinet flange
(see Figure 6) . This space can be adjusted by adjusting the top
and bottom hinge adapter brackets.
Solid Door Models
Figure 8
123/32”
(38.8cm)
Typical 4
Sides
Glass Door Models
Figure 7
Solid Door Models
Model W H
3BARM
145/8”
(37.1cm)
305/16”
(77.0cm)
6BARM
235/8”
(60.0cm)
305/16”
(77.0cm)
Table A
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen
wrench. Remove the door by angling the top of the door out-
ward and lifting the door off the bottom hinge.
(See detail in Figure 6).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To gain
access to the screw holes remove the door gasket by peeling up
and out of the channel.
Step 4: Cut overlay panel
Depending on the refrigerator model cut the overlay panel to
the dimensions shown. Use Figure 7 and Table A for solid door
models or use Figure 8 and Table B for glass door models.
W
H
Front of
overlay
panel
Figure 6
Hinge adapter bracket lo-
cated on the top and bottom
of the door.
Remove top
hinge pin to re-
move the door.
Door should be
parallel to top
and sides of
refrigerator.
H
Front of
overlay
panel
9/32”
(7mm)
W