27
USE AND CARE GUIDE FOR YOUR REFRIGERATOR/FREEZER
The second style is with a screw mount. Locate the cap-
it screw in the center of the grille back and pry off the
plastic cap with a wide flat screw driver, then unscrew the
mounting screw. CAUTION, when the screw is removed,
the grille back will be loose, do not allow it to fall. Grasp
the grille back on each side and tilt the top forward and lift
upward to free the grille back from its mounting.
The third style of mounting is with springs. The spring(s)
are located behind the grille back. The spring(s) are
mounted to the top of the cabinet and hook to the square
holes in the grille back. To remove the grille, pull the grille
forward and reach down to the spring and unhook it from
the grille back. The grille
back will be free to be removed. The louvered grille is
heavy so use care when removing. Now you can inspect
the condenser for dust accumulation.
Be sure to refasten top grille after cleaning to avoid injury,
as grille could fall if not properly fastened.
Energy Saving Tips...
• Do not open doors more often than necessary.
• Close the doors as soon as possible, particularly in
hot, humid weather.
• Be sure the doors are closed tightly.
• Before leaving the house or retiring for the night,
check to be sure doors have not been left ajar inadver
-
tently.
• Store only those foods requiring refrigeration in your
refrigerator.
• Allow hot foods to cool to room temperature before
storing them.
• Keep all foods covered to reduce moisture build-up.
• Do not waste ice cubes by letting many melt while
only using a few.
• Do not turn controls colder than needed.
If you need service...
If your unit will not operate correctly then:
1. Take the necessary steps to preserve food. Remove
and store at a neighbor’s house or other facility if
needed.
2. The doors should be kept closed if possible until the
unit is back in service.
3. Call your dealer or Service Agency. Please have bill of
sale, model and serial number available.
NOTE: Be sure to fully fill out and mail back your registra
-
tion card without delay. Failure to do so may void your
warranty.
Record both the Module model number and cabinet
model number and serial numbers on the card and below
for future reference.
The module serial plate is located on the front of the mod
-
ule. The cabinet serial plate can be located on the inside
right side wall near the bottom, or on the ceiling of the
compartment.
Power Module
Condenser
(behind top grille)
Lower Cabinet
(food storage)
For Your Records
Date of Purchase
Dealer’s name
Dealer’s Address
Dealer’s City
Dealer’s State and Zip Code
Cabinet Serial Number
Cabinet Model Number
Module Serial Number
Module Model Number
Date Warranty Card Sent (Must be
within 10 days of purchase).