L A 5 0 0 0 L I Q U I D A P P L I C A T O R O P E R A T I O N & M A I N T E N A N C E M A N U A L
6
1. Ensure applicator is connected securely to tractor draw bar
with clevis pin and safety chain (Figure 1).
2. Connect applicator hydraulic hoses to the tractor remote
couplers. The blue hoses are for the main bar height control.
The green hoses are for the outside wing fold. The yellow
hoses are for main wing fold on 35’ through 40’ bars. The red
hoses are for the hydraulic pump (Figure 2).
OPERATING INSTRUCTIONS
6. Remove locking collars as needed to maintain a depth
of 4 to 5 inches. Constant down pressure on main lift is
not recommended (weight of toolbar will keep unit in
the ground). Leave hydrualic selector in neutral for field
operation (Figure 3).
7. Remove safety pins on wing cylinders. Wing cylinders
remote will run in constant while down (Figure 4).
3. Connect wiring harness if using hydraulic pump with rate
control.
4. Grease Applicator (Refer to Mainentance).
5. Before road travel, install all locking collars on toolbar
cylinders and safety pins on wings.
FIG. 1
FIG. 2
FIG. 4
FIG. 3
The Applicator is equipped with adjustable down pressure relief
valve on wing cylinders. The valve is preset at 800 PSI. This may
be adjusted as needed. The relief valve is located on drivers side
of linkage arm mount, and requires an allen wrench to adjust
(clockwise to increase pressure and counterclockwise to decrease
pressure. Figure 5).
FIG. 5
