EN
4
© Copyright LOTRONIC 2018
DMX ADDRES SETTING
Every unit must have a specific starting address. During signal transmission, the unit will receive
channel control signals from the DMX controller through this starting address.
According to different requirements or for ease of use, the user can set several units to the same
address, or alternatively, he can set up a different address for every unit.
If more than one units have the same address, all of them will receive the same DMX channel signal
from the DMX controller. All connected units are jointly controlled, DMX controller can't control a
device separately.
If every unit has a different address, they will be separate and accept separate DMX512 control
signals through the separate DMX addresses, so that every unit will be controlled separately. this
method must be based on channel quantity of device to determine a starting address.
This device has 6 channels, so the starting address of the first device will be set to 1, the second is
7(1+6), the third is 13(1+12) and so on.
Address 13
Address 7
Address 1
REAR PANEL
1. IEC IN/OUT
1
2
3
4
2. Safety rope
3. DMX In/Out
4. LED display
MENU
Display
Display
Function
Addr
Enter
/
001-512
Set DMX address
Chnd
Enter
/
3CH
3 DMX channels
6CH
6 DMX channels
Shnd
Enter
/
Sh1-Sh15
Built-in shows from 1-15
SLnd
Enter
/
Mast
Master unit
SL 1
Slave unit
Lost
(no DMX signal)
Enter
/
soun
Run sound mode if no DMX signal
Auto
Run Auto mode if no DMX signal
blac
Blackout if no DMX signal
SP_A
Enter
/
A.001-A.100
Auto show, speed low to fast
