EN
3
www.afx-light.com
•
Make sure the power cord is never crimped or damaged.
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
•
The product is for decorative purposes only and not suitable as a household room illumination.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
•
If the lenses are visibly damaged by scratches or cracks, stop using the unit immediately and
replace the damaged lenses.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
FUSE REPLACEMENT
•
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
•
With a Phillips head screwdriver wedge the fuse holder out of its housing.
•
Remove the damaged fuse from its holder and replace with exactly the same type of fuse (BGDP
Ø5x20mm 250V~2A).
•
Insert the fuse holder back in its place and reconnect power.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always en
-
sure that the unit is firmly fixed to avoid vibration and slipping while opera
-
ting. Always ensure that the structure to which you are attaching the unit is
secure and is able to support a weight of 10 times of the unit’s weight.
The installation must always be secured with a secondary safety attach
-
ment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting, removing or servicing
the fixture.
Insert an M8 screw throught the Ø12.5mm hole on the hanging bracket to
fix the mounting bracket.
DMX CONNECTION
Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe
-
male 3-pin XLR input of the light.You can chain multiple lights together through serial linking
The cable needed should be two core, screened cable with XLR input and output connectors. Please
refer to the diagram below
Mounting bracket
Hanging bracket
