EN
9
www.afx-light.com
Pairing Between Master/Slave Fixtures
Before pairing master and slave fixtures, make sure you have already cleared wireless DMX mem
-
ory of the slave fixtures. This mean that all slaves' wireless DMX indicators are off.
Continue pressing “Menu” till you see “Wireless DMX”. Press Up/Down to select “Pairing” and press
“Enter”. Then the wireless DMX indicator on the master fixture and all slave fixtures will start flash
-
ing fast and then stay on. Pairing has been successful. Now you can operate your fixtures wireless
-
ly in Master/Slave mode.
Clear Wireless DMX Memory
To clear wireless DMX signal, continue pressing “Menu” till you see “Wireless DMX”. Press Up/Down
to select “Clear” and press “Enter” to erase the previous wireless DMX signal. Wireless DMX indi
-
cator will turn off after 5 seconds. If your fixture is a master unit (i.e. it is in wireless DMX transmit
mode), the wireless DMX memory of both Master unit and Slave units will be erased at the same
time. If your fixture is a slave unit, you cleared wireless DMX memory of that fixture only.
DMX Signal Fail
To access the DMX signal fail setting, press the “MENU” button and use the “UP” and “DOWN”
buttons to show FAIL on the OLED display. Now press the “ENTER” button and use the “UP” and
“DOWN” buttons to choose between Hold, Blackout or Auto mode. Press the “ENTER” button to
save your setting. Press the “MENU” button to exit the above options.
DMX CHANNEL CHART: SEE THE END OF THE MANUAL
Master/Slave Mode
The fixture has a built-in wireless DMX transceiver inside. Fixtures can operate in Master/Slave
mode wirelessly or with physical XLR cable linking. In Master/Slave mode, one fixture will work as
Master fixture, other fixtures in the daisy chain will work in synchronization with the Master fixture.
Continue pressing “Menu” till “Mast/Slave” appears, scroll “Up” or “Down” to set up one fixture
as Master unit. Then press “Enter”, the master unit will start to pair all slave units automatically.
Wireless DMX indicator keeps flashing during pairing process. Wireless DMX indicator keeps On if
pairing succeeded.
Auto Run Mode
The fixture has preset color mixing and fading programs that can be activated from the OLED
control panel for auto running. To access this, follow below steps:
•
Press button “Menu” until “Program” appears.
•
Press “Up” or “Down” to scroll up/down to select “Auto” and “Color”;
•
Press “Enter” to confirm your run mode;
•
Scroll “Up” or “Down” to select Auto programs
Sound Mode
The fixture can operate in sound mode to activate the built-in programs with music.
Continue pressing “Menu” till “Program” appears. Press “Up” or “Down” to scroll up/down to select
“Sound”. Press “Enter” to save the setting.
Press “Up” or “Down” to adjust sound sensitivity from high to low (from 1 to 9).
Manual Colors
