EN
3
www.afx-light.com
•
In the event of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
•
Make sure the power cord is never crimped or damaged.
•
Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
•
The product is for decorative purposes only and not suitable as a household room illumination.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
•
The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
•
The light source of this device is not replaceable. If it is defective, the entire unit must be discard
-
ed.
•
This product is not designed for permanent operation. Consistent operation breaks will ensure
that the device will serve you for a long time without defects
•
Always switch off the fixture when it is not in use or before cleaning it or before attempting
any maintenance work
.
OUTDOOR USE
The unit can be used outdoors under certain conditions and under the sole responsability of the
user:
•
The unit must be placed in a perfectly vertical position.
Do not tilt the unit
!
•
The base must never be exposed to rain or water. Make sure that no water can accumulate around
the base or enter the housing.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
BATTERY CHARGE
A rechargeable lithium ion battery and auto-ranging charger is built inside this fixture. Please
avoid bumping or plunging, it may cause fire or explosion. Always store the fixtures with full bat
-
tery. Depleted batteries must be recharged immediately; otherwise fixture performance will suffer.
There are two ways to charge the fixture.
1. The fixture has a charge connector in the base. If you have a flight case (model FL6-IBOX), just
drop the unit onto the charging connector in the charging case, and plug the case to the mains.
The fixture will start to charge automatically. A normal charging time is about 4-5 hours.
The flight case must be open during charge.
2. Users can also charge the fixture with AC power 100-240V~. Connect the fixture power
input to the mains with the enclosed power cable, it will start charging automatically.
Battery capacity can be easily seen on the OLED display.
BATTERY LEVEL INDICATOR
There is a charge indicator on the top of the fixture. When the battery capacity is less than 30%,
the yellow light will start flashing. When this happens, charge the battery immediately till it is
100% charged. The red light will turn on during the whole charging process. Once the battery is
fully charged, the indicator will turn on green.
Yellow flashing
– power less than 30%, need to charge battery
Red
– battery being charged
Green
– battery fully charged
•
It is recommended to charge the fixture at an ambient temperature between 0°C and 35°C.
•
When charging fixtures in a flight case,
make sure to keep the case open
. Battery always
charges whenever the fixture is placed on the charging connector. If the fixture is charged but not
in operation, please always keep the power switch in “Off” position.
Note: The battery must be replaced with an original one from the manufacturer only.
