WIRELESS SET
There is one transmitter and one receiver included. You may control up to 4 independent fog machines, or as many
as you want simultaneously. See the below instructions to how to operate the wireless remote.
1. Plug the wireless receiver into the fog machine’s 5-pin connector on the rear panel marked “Wireless Controller”.
2. There are 4 buttons on the transmitter. Each button can be assigned to a different fog machine. You may only
choose 1 DIP switch on every receiver. See the below configuration for setting the receivers to operate with the
transmitter.
CH1 1=On,2-4=Off
CH2 2=On,1,3,4=Off
CH3 3=On,1,2,4=Off
CH4 4=On,1,2,3=Off
During heating time, the heating led lights on. When the fog is ready to spray, the status led lights up.
WIRELESS RECEIVER
The red LED indicator on the remote is just a power supply indicator, the Green LED indicator does not turn Green
when the machine is ready to fog, but you can check this from the LCD display if it is ready
OPERATION INSTRUCTIONS
1. After checking that all the parts are intact and complete, position the machine on a flat surface.
2. Pour carefully DJ fog liquid into the tank and screw the cap.
3. Connect the power cord. Before power on, make sure it is connected to an outlet supplying the rated voltage.
4. Turn on the machine, it will immediately start heating up. The LCD display will show “WARMING UP”.
5. It takes about 5 minutes for FOG3000T to heat up completely. The LCD display will change to “READY TO
FOG” when it is ready. After the first time’s work, it will take another 1 minute to reheat up.
FOG3000T is fitted with a W-2 wireless controller. Under wireless remote mode, it will work at largest output. The fog
output volume can be set by the LCD display or by DMX. This machine can keep making fog for at least 20s
continuously.
Wireless receiver
Wireless remote
control
Switch
Heating Led
Status led
© Copyright LOTRONIC 2014 FOG 3000T
Page 5
