©Copyright LOTRONIC 2015
9BEAM-FX
Page 3
Features
•
12 / 43 DMX channels
•
9x 12W RGBW LED
•
Extra long life CREE LEDs (>50,000 h)
•
3 x 3 zones
•
Narrow beams
•
DMX, stand-alone, master-slave and show modes
•
Built-in music controlled programs
•
Pulse & Strobe effects
•
Electronic dimmer 0-100%
•
Suitable for wall, truss or floor mounting
Specifications
Power supply .................................................................................................. 100-240Vac 50/60Hz
Consumption ................................................................................................................. 140W max.
Fuse ............................................................................................................................................. 3A
Light source .............................................................................................. 9x 12W RGBW CREE LED
Tilt ......................................................................................................................................... 0-185°
Pan......................................................................................................................................... 0-360°
Beam angle ................................................................................................................................... 5°
Dimensions ....................................................................................................... 458 x 429 x 208mm
Weight ................................................................................................................................... 10.6kg
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of the base,
the included ‘omega bracket’ and the safety cable rigging
point in one unit (see the illustration on the right).When
mounting this fixture on a truss, be sure to use an
appropriate clamp with the included omega bracket using
a M10 screw fitted through the center hole of the ‘omega
bracket’. As an added safety measure, be sure to attach
at least one properly rated safety cable to the fixture
using one of the safety cable rigging points integrated in
the base assembly.
SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
Fuse Replacement
With a flat head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
Fixture Linking
