AFRISO Maximelder-R, Руководство по эксплуатации

Страница: 49 / 167

15
Mounting
Minimelder-R / Maximelder-R
EN
5 Mounting
5.1 Mounting the floating probe
The floating probe is mounted in such a way that it is suspended in the tank.
The height at which the float switch of the floating probe is mounted corre-
sponds to the alarm switching point.

Verify that the correct floating probe for Minimelder-R or Maximelder-R is
mounted (fee figure “Floating probe” on page 7).
1. Suspend the floating probe into the tank at the cable.
2. Fasten the floating probe cable with the enclosed G1 screw fitting at the
height/level of the required alarm switching point.
3. Alternative: Fasten the floating probe with a cable clamp or a cable gland.
5.2 Mounting the control unit
Select a mounting position where the audible alarm signal can always be
heard, even in the case of ambient noise. If audibility cannot be ensured, you
must install an additional alarm unit at a suitable location.

Verify that the control unit is mounted to an even, rigid and dry wall at eye
level.

Verify that the permissible ambient temperature is respected at the control
unit.

Verify that the control unit is accessible and easy to oversee at all times.

Verify that the control unit is protected against water and splash water.