4
Information on safety
EN
HMS
2.2
Intended use
This product may only be used to signal accumulations of liquids during mon-
itoring of:
•
Collection facilities under storage tanks, burners or motors
•
Tanks with collection facilities which are not visible
•
Collection facilities below devices consuming oil
•
Manholes, pipe and cable ducts
•
Pump and control stations where oil can accumulate due to leaks or back-
flow
The product is suitable for liquids to which the material of the photoelectric
probe is sufficiently resistant, such as:
•
Diesel fuel (DIN EN 590) and low-viscosity oils with flash points of > 55 °C
at atmospheric pressure and at temperatures of -10 °C to 60 °C in dry
rooms
•
Synthetic fuels (GTL) as per EN 15940
•
Fuel oil EL
•
Unused and used motor oils (for example, SAE 15W-40), gearbox oils
and hydraulic oils, transformer oils
•
Vegetable oils, hydrogenated vegetable oils (HVO)
•
AdBlue® (urea solution 32.5 %) as per ISO 22241
•
Water, grey water
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
•
All directives, standards and safety regulations applicable at the installa-
tion site of the product
•
All conditions and data specified for the product
•
The conditions of the planned application
In addition, perform a risk assessment in view of the planned application,
according to an approved risk assessment method, and implement the
appropriate safety measures, based on the results of the risk assessment.
Take into account the consequences of installing or integrating the product
into a system or a plant.