7
Note:
A 10AMP, 230V circuit is required to operate this appliance. Dedicated circuit
is preferred but not essential in all cases, a dedicated circuit will be required if,
after installation, the circuit breaker trips or the fuse blows on a regular basis
when the heater is operating. Additional appliance on the same circuit may
exceed the current rating of the circuit break.
Warning:
1. Ensure the power cord is not installed so that it is pinched or against a
sharp edge and ensure that the power cord is stored or secured to avoid
tripping or snagging to reduce the risk of fire, electric shock or injury to
persons.
2. Construction and electrical outlet wiring must comply with local building
codes and other applicable regulations to reduce the risk of fire, electric
shock and injury to persons.
3. Do not attempt to wire your own new outlets or circuits. To reduce the risk
of fire, electric shock or injury to persons, always use a licensed
electrician.
INSTALLATION:
1. Please confirm the power is off when you start to installation.
2. Plug in the unit into the power, the power should be no less than
10Amp/230V AC. If the power cord is not long enough, you can use
an extension cord that the power is no less than 2000W.
www.aflamo.pl/en/
