Afikim afiscooter-s, Руководство по обслуживанию

Страница: 15 / 37

Service Manual AFISCOOTER S v.1.9
Ver. 01
15
8.
Controller Programming And A List Of Programming Parameters
8.1 General
The scooter behavior while driving can be adjusted by programming the controller, for
example slowing down, changing the direction of operation of the operating handle and
more. Only a qualified technician may change the controller programming.
Warning: Bad programming of the controller can cause safety problems in the behavior
of the scooter.
The following parameters refer to the s-drive 140 controller with sp1a manual
programming.
Programming can be done through the charging socket with an adapter or directly to the
programming socket in the controller without an adapter.
Note: You can also purchase a PC programming system.
Charger Socket Adapter P/N - ASS4079 Programmer sp1a P/N - PCS4002
Note: In case of any need to change a parameter that is not highlighted in the list, please contact
and consult with Afikim Electric Vehicle Engineering.
8.2 Operating Instructions
8.2.1 Connect the adapter to the programmer and plug into a charging socket (the
programmer starts working).
8.2.2 The up and down arrows (↑) (↓) allow the parameter to be selected.
8.2.3 To change a parameter, see the parameter in the display bar and press the "ENTER"
button, then the value of this parameter appears.
8.2.4 Using the arrows (↑) (↓) you can increase or decrease the value. (In some cases a
change between Off and On).
8.2.5 After setting the new value press the "ENTER" button, the scooter buzzer will beep
several times (in this situation the scooter will not travel).
8.2.6 The key switch must be closed and activated in order to return the scooter to normal
operation. (Some parameters value is determined in pairs).
8.2.7 Programmer returns to the list of parameters. To change another parameter repeat
the previous 3 sections
8.2.8 In the engineering menu bar enter the change of engineering parameters.