Afikim Afi-lite Plus, Руководство пользователя

Страница: 21 / 39

February 27, 2003 Afi-lite User Manual
15
Side B Side A
Chapter 3: Setting Afi-lite Parameters
Parameters are variables that must be given a value, for the execution of a program.
Some parameters in the
Afi-lite software control cluster removal functions. Another
parameter defines the milk meter identification number of each milk meter. This
chapter describes how to set cluster removal and milk meter ID parameters.
Milk Meter Identification Parameter
Each milk meter must be assigned an identification number. ID numbers are
assigned during installation. Normally the user does not need to assign an ID
number. In the following two situations, however, an ID number must be assigned:
•
When replacing milk meters, the new
meter needs an ID number.
•
If there has been a complete reload of
default parameter values. (A partial reload
preserves the original ID number.)
The identification number of each milk meter is
displayed on its control panel with four digits. It
begins with the letters
, followed by two
numbers. For example, is the
identification number for milk meter number five.
For a herringbone parlor, milk meters should be
numbered in the same pattern as illustrated.
Check ID numbers of adjacent meters to ensure
that you enter the correct ID number. The default milk meter identification number
is 66. Enter the milk meter identification number as follows:
The new Id number is entered.
1.
Enter programming mode:
Press , and simultaneously. and alternate on the display.
2.
Press
&
simultaneously.
StuP
appears for a few
seconds.
Then
1d
appears.
3 . When
1d
appears,
type the identification
number of the milk
meter (example: 5).
4. Press
&
simultaneously
to enter the new identification number,
or press to abort the change
and exit programming mode.
NOTE:
At all times, the milking station identification number can be displayed by
pressing and simultaneously.
this page updated June 19, 2003