Page 22
12/02/2020
R05.1
5.4
Setting the air gap between magnetic coil and anchor bolt
This procedure is only necessary when:
-
The distance between the oscillation and the support surface has been reset
-
Springs or spring packages have been exchanged
-
The magnetic coil has been replaced
WARNING
Unplug the power cable, before proceeding with further actions!
NOTE
Before setting the air gap, check the parallelism (1mm) and the
distance between the oscillation plate and the support.
1.
Turn the anchor bolt
(see Figure 9,Figure 10)
,
therefore:
LF9: Loosen socket screw (2.5 mm). Turn the anchor screw (3) with your
hand into the corresponding direction.
2.
The air-gap between magnetic coil (4) and anchor screw (3) is to be adjusted by
means of a feeder gauge (5) according to Table 1: Technical data
If the magnetic coil and the anchor bolt clash together, then
the air gap is too small.
