R03.0
16/05/2019
Page 11
3
Assembly instructions
3.1
Transport
WARNING
Improper use of transport means (industrial trucks, cranes, technical aids,
sling gear etc.) may lead to bruises and other injuries.
Required behaviour:
-
Observe and follow the transport and maintenance instructions
-
Proper use of transport means
CAUTION
During transport, the linear feeder must only be held by the base.
The linear track is no lifting point.
3.2
Installing the unit
The HLF
-P
is firmly screwed to the foundation structure by means of slots provided in
the base plate (see Figure 2). This precisely defines the interfaces where the feeder
track enters and exits as well as allowing adjustment. The substructure should be
non-oscillating in a horizontal plane in order to be able to take up any residual forces.
Self-supporting profile constructions have to be reinforced with a base plate to which
the Linear Feeder is attached. A steel plate of at least 20mm thickness and a width of
over 120mm should be used for this purpose. The vertical oscillating forces respon-
sible for energy induction in the foundation structure should be virtually completely
eliminated by a careful balance of weights (see chapter 4.2 Balance of weights).
Height adjustments can be achieved by means of appropriate substructures. Stand-
ard Afag components are available for setting up complete units.
Figure 2:
Attachment slots in the base plate
Slots for attaching the HLF-P
