10
C. assemble stantions
1.
Pre-Assemble all four stantions as shown (fig. 11) leav-
ing finger tight at this time.
NOTE: Additional hardware is
included that is not required for this application.
Adhere
the adhesive backed foam to the stantion foot, cut holes
for the bolts to pass through, and trim tight to foot. Adhere
the AEV Logo Decals to the stantions using the supplied
alcohol swab to first clean the surface.
2. Reinstall Hard top on Vehicle. Top must be completely
secured with all factory fasteners.
3. Position stantions on hard top inserting bolts through the
newly drilled holes.
4.
Working from the inside of the vehicle, fasten lock nuts
onto stantion bolts and finger tighten
D. Attach platform
1. Lift platform onto vehicle. Channel cutouts should be at
the rear of the vehicle.
2. Insert stantion channel nuts into platform cross bars.
Stantions connect to crossbars #1 and #4 if counting from
the rear of the vehicle.
3. Center platform Left and Right over vehicle.
4.
Tighten all fasteners, leaving the saftey allen head screw
for last.
5. Reinstall sound bar.
adhesive foam
non-locking nuts
AEV logo decal
Figure 11
