Aesculap Econom CL, Инструкция по эксплуатации

Страница: 8 / 174

6
Econom CL/Econom CL Equipe/Econom CL Fitter cattle and horse clipping machine
Aesculap®
¾
Remove the lithium ion battery 39 , and push the charged replacement
lithium ion battery GT801 into the battery-operated clipping
machine
g , see Fig. 2.
Fig. 2
¾
Secure the lithium ion battery 39 using the battery lock f , see Fig. 3.
Fig. 3
4.5 Handling the cutter head
Lubricating the cutter head
¾
Generously oil the cutter head at the lubrication point a before
shearing each animal, see Fig. A.
¾
Oil spring leaves 10 2 to 3 times daily with 3 to 4 drops of oil, see
Fig. C.
Lubricating the gear wheel
¾
Unlocking and removing the lithium ion battery 39 .
¾
Remove both screws 6 , see Fig. B.
¾
Then turn the cutter head very slightly (about 15°) counterclockwise
and remove it from the motor shell.
¾
Apply approximately 1 cm of grease on the two opposite points of the
gear wheel
11 , see Fig. C.
¾
Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor
housing.
Changing the cutter plate
¾
Unlocking and removing the lithium ion battery 39 .
¾
Loosen the locking cap 3 and adjusting screw 4 by approx. 2 turns, see
Fig. A.
¾
Loosen both clamp screws 9 , pull off the cutter plate 1 forwards and
remove the upper cutter plate 2 , see Fig. D and Fig. E.
¾
Before inserting the upper cutter plate 2 , ensure that the oscillating
block 8 is in the intended recess of the oscillator 7 , see Fig. E.
¾
Insert the upper cutter plate 2 . When doing so, ensure that both tips b
of the oscillator 7 engage precisely in the holes c of the upper cutter
plate 2 , see Fig. D.
39
f
39
CAUTION
Damage to the clipping machine or the cutter
head due to incorrect lubrication!
¾
Only oil the cutter head when the machine is
running.
¾
Never immerse the cutter head in liquid of any
kind!
¾
Only use GT604 light lubricating oil.
CAUTION
Damage to the clipping machine or the gear wheel
due to incorrect lubrication!
¾
Use only gear grease GT605.
¾
Lubricate the gear wheel 1 to 2 times during
the shearing season.