40-7705ii-C-IS
Page 5
Rev 1 March 16, 2018
2.2
MultiNet Receiver Installation
Refer to the “AES 7705ii-C MultiNet Receiver System – User Manual” and the
following additional information on the Installation and Setup
Connect a keyboard, video monitor and mouse to the receiver. These are
required for initial setup.
The 7705ii-C receiver, monitor and any network related equipment must be
connected to a suitable ULC Listed, 864 UPS to maintain power during power
outages.
Each MultiNet receiver and 7170-C IP-Link Transceiver pair is shipped with
identical network configurations. At least one pair requires change to TCP/IP
configuration before connecting the two into the same network together.
Refer to figure in the “AES 7705ii-C MultiNet Receiver System – User
Manual”
for system illustrations.
MultiNet receiver installation steps:
1.
Mount or locate the 19” rack mountable MultiNet receiver in your selected
location. A UL-60950 listed 19” rack mount cabinet is required.
2.
Install and connect the monitor, keyboard and mouse to the proper
connections on the rear panel of the Receiver as shown in manual
diagrams. This is for initial setup only.
3.
Do not connect Ethernet ports to a live network. Until network settings are
confirmed and/or modified, leave the Ethernet cables disconnected for 1st
time power up.
a.
Because the MultiNet Receiver is preconfigured as shown in the
MultiNet Receiver System User Manual, it is OK to connect a
7170-C IP-Link Transceiver to Port 1 of the MultiNet Receiver
using an Ethernet Crossover cable like the one supplied.
b.
After configuring TCP/IP, you can connect the Ethernet port(s) to
appropriate connections of your network. This will allow
communication to the IP-Link Transceiver(s), secondary MultiNet
Receiver(s).
4.
Connect the printer. Use a printer listed by ULC for “Signaling Use” such
as an AES 75-0101.
5.
Plug the MultiNet receiver, monitor and printer power cords into power
outlets. A UL Listed UPS (UL864) or UL1481 power supply is required.
