40-7705ii-C-IS
Page 4
Rev 1 March 16, 2018
2.0
Installation
The installation process outlined in this document suggests that you first install
the 7170-C IP-Link transceiver up to the point where power to the IP-Link is
ready to be applied. Then continue by installing, powering and configuring the
7705ii-C MultiNet receiver. Follow this by the powering and configuration on the
7170-C installed previously.
2.1
7170-C IP-Link Installation
The first two 7170-C IP-Link transceivers are typically installed at the same
physical location as the MultiNet receiver. Position the IP-Link as close to the
antenna location as possible. The IP-Link location should result in the shortest
and straightest run of coax to the antenna. A 200-foot separation of the antennas,
IP-Link and associated equipment is required for proper system supervision.
Place the IP-Link Transceiver and associated equipment in a location away from
the outdoor environment. Refer to the provided “AES 7170-C IP-Link
Transceiver Installation and Operation Manual” for installation details.
The antenna and any surge devices must be bonded to a good earth ground in
accordance with the Canadian Electric Code and applicable Local Codes.
Install and prepare the 7170-C IP-Link transceivers to connect to power, phone
and network. Follow the installation instruction in the
“AES 7170-C IP-Link
Transceiver Installation and Operation Manual”
provided with the IP-Link
units and stop when instructed to turn on power to the unit. An outline of the
process is below.
IP-Link Transceiver installation steps:
1.
Mount the transceiver in your selected location.
2.
Install the surge protector, antenna, and coax.
3.
Prepare phone connection.
4.
Prepare network connection.
5.
Prepare but do not connect the AC power connections.
6.
Continue with MultiNet receiver installation prior to initial power up.
