AES 7058E RF Subscriber Unit -- Installation and Operation Manual
AES Corporation
8
P/N 40-7058E Rev 2.1 11/11/2014
►
OWNER WARRANTY – AES CORPORATION
LIMITED PRODUCT WARRANTY AND
TECHNOLOGY LICENSE
LIMITED PRODUCT WARRANTY:
AES Corporation (“AES”) warrants to the original purchaser
that each AES Subscriber Product will be free from defects in
material and workmanship for three (3) years from date of
purchase and all other products purchased from AES including
central station receivers and accessories will be warranted for
one (1) year from the date of purchase. At no cost to the original
purchaser for parts or labor, AES will repair or replace any AES
Product or any, part or parts thereof which are judged defective
under the terms of this Warranty.
Defective AES Products must be returned to AES directly,
provided they are properly packed, postage prepaid. Or
exchange may be made through any authorized direct factory
representative for any AES Products that are judged defective
under the terms of this Warranty. Improper or incorrectly
performed maintenance or repair voids this Warranty. This
Warranty does not cover replacement parts that are not approved
by AES. This Warranty does not apply to any AES Product or
any part thereof that has been altered in any way to affect its
stability or reliability, or that has been subjected to abuse,
misuse, negligence, accident or act of God, or that has had the
serial number effaced or removed.
Certain AES Products are designed to operate and communicate
with other specified AES Products and certain other specified
products, systems or networks authorized or approved by AES,
as identified in the applicable AES Product instructions. This
Warranty does not apply to any AES Product that is used with
any unauthorized or unapproved products, systems or networks,
or that has been installed, applied or used in any manner, other
than in strict accordance with AES instructions.
AES makes no warranty, express or implied, other than what is
expressly stated in this Warranty. If the law of your state
provides that an implied warranty of merchantability, or an
implied warranty of fitness for particular purpose, or any other
implied warranty, applies to AES, then any such implied
warranty is limited to the duration of this Warranty.
AES cannot be aware of and is not responsible for the differing
values of any property to be protected by its alarm reporting
systems. This Warranty does not cover and AES shall not be
liable for any defect, incidental or consequential, loss or damage
arising out of the failure of any AES Product to operate.
Some states do not allow the exclusion or limitation of the
durations of implied warranties or the limitation on incidental or
consequential damages, so the above limitations or exclusions
may not apply to you.
This Warranty gives you specific legal rights and you may also
have other rights that vary from state to state.
TECHNOLOGY LICENSE:
Certain AES Products include software, protocols and other
proprietary and confidential technology and trade secrets of AES
which are incorporated in or provided with AES Products solely
for use in conjunction with and in order to operate AES Products
(“Licensed Technology”). AES grants the original purchaser a
non-exclusive license to use such Licensed Technology solely in
connection with the use and operation of AES Products and for
no other purpose or use whatsoever. No title or ownership in or
to any such Licensed Technology is conveyed by the sale or
delivery of any AES Products; all such rights are retained by
AES.
Warranty Rev date June 2007
► Troubleshooting
The most common causes of an RF failure or trouble are due to
issues with the transmission line including but not limited to
the antenna type, antenna location, coax, connectors, and
transceiver. Antennas in close proximity to metal or with
conductive material blocking or reflecting the transmitted
signal would be at the top of the list. Observe the RX light on
the 7058E. If it is on steady or most of the time you may be
receiving some RF or electrical interference. Try different
locations for the antenna or use a remote long range RF
antenna. Try replacing transmission line components such as a
new transceiver, the coaxial connectors, coax and antenna.
Problems on the circuit boards usually require returning the
defective unit to AES for service. Antennas should be mounted
at least 5-10 feet above the roof line on roofs containing
significant metal surface.
► Maintenance
Once installed and normal operation is confirmed, there is
typically little maintenance required. Monitoring the automatic
test messages will confirm proper RF operation. Batteries
should be periodically tested to be certain they have sufficient
capacity to operate the system as needed.
►
AES SERVICE PROCEDURE:
Contact AES by Phone (978) 535-7310, Fax (978) 535-
7313 or Email [email protected], to receive a
Return Material Authorization Number. Have the AES
part number and serial number ready. Repack
equipment in original or equivalent packaging. Inside the
box, please include a contact name, telephone number,
address and a brief description of the reason for return.
Ship items freight-prepaid to:
Repair Services, RMA#_____
AES Corporation,
285 Newbury Street
Peabody, MA 01960 USA
(Contact AES for Return Material Authorization number)
FCC Identification: AES Model 7058E Subscriber Unit
This unit complies with FCC part 68 as of date of manufacture.
FCC# 5IWUSA-47000-MO-N Ringer Equivalence 0.0B Jack: Barrier Block
• FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: Reorient
or relocate the receiving antenna; Increase the separation between the equipment
and the receiver; Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected; Consult the dealer or an experienced
radio/TV technician for help. CAUTION: Changes or modifications to this
equipment not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
• CANADIAN COMPLIANCE
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the interference-causing equipment
standard entitled "Digital Apparatus", ICES-003 of Industry Canada.
Cet appareil numérique respects les limites de bruits radio électriques
applicables aux appareils numériques de Classe B prescrites dans la
norme sur le matériel brouilleur: "Appareils Numeriques", NMB-003
édictés par l'Industrie Canada.