AES 7058E RF Subscriber Unit -- Installation and Operation Manual
AES Corporation
3
P/N 40-7058E Rev 2.1 11/11/2014
►
Wiring – Antenna Cut /
Acknowledge Delay Output (J4)
If the radio channel is "quiet" for more than 6 minutes (as
would be the case if the antenna was cut) the 7058E subscriber
attempts to send a test message to another subscriber. If that
message is not acknowledged within the programmed
acknowledgment delay period (default is 2 minutes), a fault
condition exists. This fault condition is annunciated at J4,
which is a 12V open collector output. The pin closest to the
heat sink grounds on activation. The pin closest to the LEDs
is connected to +12V. (See diagrams below). The voltage
can be used to drive a relay, sounder or other device to notify
someone of the condition. Maximum load is 200 mA. An
“Acknowledge Delay” message is also added to the transmit
queue to be sent when the unit re-connects to the network.
(Seen as an R356 E903 or T903 in automation)
The (+) pin of J4 is internally connected directly to the 12
Volt supply. A fuse is recommended between J4+ and the
relay.
The (–) pin is switched to ground by an internal transistor.
Maximum load is 200 mA.
►
Status (LED) Indicators
LED Indicators on Circuit Board
There are 4 LED’s on the main circuit board of the 7058E.
The function of each is described below.
TX
–
(Red) indicates radio transmit
RX
–
(Green) Indicates radio receive (includes any
radio activity on this frequency strong enough to
break squelch)
WA
–
(Yellow) Steady On = Waiting for
acknowledgment of last transmission;
–
Steady Blinking = Not on Network; Off = Normal
ALM
–
(Red) Status / troubleshooting indicator,
See “…Blink Patterns” below
►
Red ALM LED, Blink Patterns
Blink Codes: “●” = short “▬“ = long. Period between
patterns is about 1 second with diagram showing 3 repeats.
|1 second|
●
●
●
Steady blink – System OK;
●●
●●
●●
Short-Short blink – low battery;
●▬
●▬
●▬
Short-long blink – an input is in
alarm or trouble
●●▬ ●●▬ ●●▬ Short-short-long blink – low batt
& zone in alarm or trouble
● ●● ● ●● ● ●● short-pause-short-short, AC Fault
●● ●● ●● ●● ●● ●● short-short-pause-short-short,
AC Fault and low battery
▬▬▬▬▬▬▬▬▬ Steady / no blink – Self test fail
(Excluding low battery)
► Parts List
The standard 7058E RF Subscriber includes the following
items.
Transceiver, Part number varies (7085-UE5 is most
common)
7214 UHF Tamper Resistant Antenna Assembly
40-7450-S Instruction manual