Aerus Pure & Dry, Руководство пользователя

Страница: 10 / 20

10
You have the ability to filter and purify air with your Pure & Dry dehumidifier by using the
HEPA/Activated Carbon Filter. Activated Carbon Filters can effectively remove VOCs, dust,
smoke and odors from the air. HEPA filters effectively remove dust and allergens.
Once the unit reads that the filter has been installed, the Air Purification Mode will light up
and the interior fan will begin to run at high speed. You can control the speed of the fan by
selecting the Humidity Set Key
%
M
. This will allow you to choose between High and Low
wind speed.
The unit will not operate if a filter is not detected in Air Purification Mode. The filter light will
flash, indicating that a filter needs to be installed.
NOTE: Depending upon usage and environment, we recommend you change the HEPA/
Activated Carbon Filter each season but no less than once every 8 months. The unit
will keep track of how many days your filter has been working. When the filter is
replaced, press the FILTER TIMER to reset.
INSTALLING HEPA/ACTIVATED CARBON FILTER
1. Open front panel and remove the
washable Pre-Filter by unsnapping from
its notches.
2. Place the HEPA/Activated Carbon Filter
into the plastic frame. Place the
washable Pre-Filter back over the HEPA/
Activated Carbon Filter and snap back
into place.
3. Close front panel. Insert tabs at bottom
into base and push closed at top. It is
held into place by magnets.
CAUTION: Disconnect power before changing filter.
!