Page 34 of 36
AER.MIU.HWN2EC.01.03/14
Upon completion of changing timer settings for the selected day, press
TI MER
button again to exit timer
programming mode. The settings will then upload to the selected slave unit. The next day of the week’s settings can
be done only upon completion of sending data to the slave units. (Repeat steps 1~4 if setting is required for the next
day of the week).
In Global control mode:
Pressing the master unit’s
CANCEL
button for 3 seconds will cancel all timer settings in all slave units.
Timer settings will be broadcast to all slave units.
e)
Clock synchronization by master unit is as follows:
Press
TI ME
and
TI ME
buttons for 3 seconds to activate clock synchronization in all slave units. Master wall pad will respond
with a beeping sound.
f)
Key lock
In order to prevent unauthorized access to the system setting, a key lock function is provided. Hold down
and
for
3 seconds to activate key lock,
symbol will lights up. Repeat the same to exit key lock. Only
button is applicable
in key lock mode.
g)
Swing
Not applicable
h)
Sleep
Press
SLEEP
button to activate or deactivate sleep setting. The Sleep function is valid in cool or heat modes only.
i)
Temperature setting
Press
or
to enter into temperature setting mode, The temperature display area blinks indicating the current set
temperature. Press the above buttons to adjust the set temperature.
j)
Mode setting
Press
MODE
button to change the operation mode.
k)
Fan speed setting
Press
FAN
button to change the fan speed. Only low speed is available for dehumidification mode.
l)
ON/OFF control
Press
to start or stop the unit.
m)
Networking Master - Slave Control (only master unit wall pad can control other units on the network)
Press
NET
button to enter into networking control mode. Unit’s display area blinking indicates the slave unit under
control. Press
TI ME
or
TI ME
to select the desired slave unit; Units that are off will be bypassed automatically. Parameters
that can be controlled are on/off, timer weekly program, set temperature, mode, fan speed, swing and sleep.
Parameter operation methods are the same as above. Press
NET
button again to exit networking control mode.
Hold down
SWI N
G
and
FRESH
buttons for 3 seconds to enter into global control mode,
will light up. Repeat the
same to exit global control mode. In global control mode, the settings of the master unit will be broadcast to all the
slave units.
n)
Unit operation parameters browsing
