Page 33 of 36
AER.MIU.HWN2EC.01.03/14
D.2.2.
Wall Pad Operation Guidelines
a)
Clock display and setting
System has an accurate internal real time clock used for time indication and timer ON/OFF function. Clock display area
indicates internal time clock which can be set by the
TI ME
or
TI ME
button.
b)
Day display and setting
The wall pad has a day display function which is used for day indication and timer ON/OFF function. Day display icon
indicates current day. Press
DAY
button to set day.
c)
Timer ON/OFF setting
If the master unit is in global control mode and the ON/OFF timer setting is selected, the master unit will command the
whole network to be on or off. Otherwise the ON/OFF timer is effective for the local unit only. The system supports
individual ON/OFF timer settings for each day of the week.
Press
TI MER
button once,
and
ON
symbol blinking indicates ON timer programming mode. While the
day display area indicates which day the timer is being set for. If there is no preset ON timer for this day is the timer
display area shows
, otherwise the previous setting will be shown. Press
TI ME
or
TI ME
button to change the
ON timer setting. Press
CANCEL
key to cancel the current ON timer setting and the timer display area will
show
. Press
DAY
button to change the day the ON timer is to be programmed for.
Press
TI MER
button again,
and
OFF
symbol blinking indicates OFF timer programming mode. The
setting method is the same as the ON timer setting above.
Press
TI MER
button again, to exit the ON/OFF timer setting function.
Should there be any ON or OFF timer settings programmed,
will light up. Should there be any
unexecuted ON or OFF timer settings for the current day, its corresponding
ON
or
OFF
icon will light up.
Hold down
CANCEL
button for 3 seconds to cancel all timer settings.
d)
Timer set by master unit is as follows:
Press
NET
button to enter into networking control mode. Unit area blinking indicates the slave unit under control.
Press
TI ME
or
TI ME
to select the desired slave unit. Units that are off will be skipped automatically.
Press
TI MER
button once to enter into ON timer programming mode. Press
DAY
button to select the required day
of the week. Master unit will then retrieve the setting from the selected slave unit and the timer display area will
show “rEAd”. The ON timer setting will be shown upon reading the data successfully. Press
TI ME
or
TI ME
button to
change the ON timer setting of the slave unit.
Press
TI MER
button again to enter into OFF timer programming mode. Press
DAY
button to select the required day
of the week. Master unit will then retrieve the setting from the selected slave unit and the timer the display area will
show “rEAd”. The OFF timer setting will be shown upon reading the data successfully. Press
TI ME
or
TI ME
button to
change the OFF timer setting of the slave unit.
