8TR1456/1
EN
D
Ø4 mm
INSTALLATION
SUPPLIED COMPONENTS
Ø4 mm
D
D
SI
NO
E
R
S1
S2
T
R
distance ≥ 150 cm
A
B
T
V
E
C
D
F
R
T
R
INSTRUCTIONS TUBÒ | ROBÒ CM189TR KIT WIRELESS
WITH START/STOP WALL MOUNTED QB
WITH RECEIVER AND TRANSMITTER COMPLETE (SPARE)
T -
wireless transmitter with ROBÒ base
A -
start/stop button
B -
wireless signal LED
C -
battery
D -
transmitter fixing support with screw
OPERATING FREQUENCY
433.92 Mhz
ACTUAL RADIO POWER
0.3mW
TYPE OF MODULATION
amplitude
(ON OFF)
ABSORPTION DURING
TRANSMISSION
10mA
COMPLIANCE WITH DIRECTIVE 99/05/EC
The remote control is compliant with the essential
requirements provided by Directive 99/05/EC.
The following Technical Standards have been applied:
EN 60335-1, EN 301489-3, EN 300220-3
E -
depression detection tube
F -
plug cable for 12V line activation
R -
appliance
Wireless receiver
V -
screws with plugs
D
-
depression detection tube
E
-
sensor input
1
- Make a hole in the case of the QB using a drill with a suitable
Ø 4mm tip, at the indicated distance.
Insert the depression detection tube
(D)
inside the QB.
2
- Make another hole using the same Ø 4mm tip in the dust-input
curved connection of the QB unit.
Insert the depression detection tube
(D)
in the sensor input
(E)
without entering inside the curved connection, as shown in the figure.
ATTENTION
If a house has several floors,
we recommend installing the
receiver on the middle floor.
The Receiver
(R)
cannot be
installed outside the house.
Inside a building, the operating
range between the receiver
(R)
and the transmitter
(T)
is 15m.
and it is capable of crossing
two floors
(S1 - S2)
