AERTECNICA TUBO CLASSIC TC, Руководство по эксплуатации и обслуживанию

Страница: 31 / 34

english
PROBLEM CAUSE SOLUTION
Low amount of air intake
There is clogging in the system Call a specialised technician.
The filter cartridge is saturated
Perform cartridge maintenance. Press
RESET to reset operation.
Multiple vacuum sockets are being used
at the same time on the system The central power unit may only be used
by one operator at a time.
The dust container gasket is damaged or
out of position Check the position of the dust container
gasket.
The air exhaust line is clogged
Check if the air exhaust line is free or if
two air exhaust openings are blocked.
The hose is partially obstructed. Free the obstruction from the hose.
The cap was not inserted correctly into
the dust inlet not being used in the
central power unit
Check that the dust inlet that is not being
used is closed with the special cap.
The built-in vacuum socket is damaged Call a specialised technician.
The central power unit always
remains activated even with the
sockets closed
The microswitch or the electric contacts
in a vacuum socket are damaged.
Call a specialised technician.
The AVT panel remains off
The central power unit power supply
cable is disconnected
Connect the power supply cable.
The protective fuse burnt out. Call a specialised technician.
The electronic card is defective. Call a specialised technician.
Call a specialised technician for other causes that are not covered in this manual
anoMalY anD locK table
- (for CLASSIC TC central power units)
MAINTENANCE SIGNAL LOCK INTERVENTION
MAXIMUM
VACUUM
EXCEEDING
TEMPERATURE
IN THE MOTOR
CHAMBER
The symbols blink
The symbols blink
The central power unit is locked
because the airflow is not
sufficient.
After the maintenance press the
PRESS RESET button to switch off
the lock signal and reset to
normal use.
Wait until the temperature of the
motor lowers below 55°C. When
this value is reached the PRESS
RESET light lights up and the
motor can be restarted. The central power unit is locked
because the temperature of the
motor chamber exceeded 80 °C.
The central power unit is locked
because the operating vacuum
exceeded 240 mbar.
Maintenance Maintenance 31