Tel. +39 049 641 679
|
|
www.aercomponents.it
19
EN
0. WARNINGS & SAFETY INFORMATION
– This unit has to be used under proper conditions according to its technical
specification and design purpose. (Otherwise responsibility belongs to practitioner)
– Unauthorized personnel must not interfere in unit and/or must not use unoriginal
spare parts. (Otherwise responsibility of failure that may occur belongs to practitioner)
– Do not install this product in a refrigerated warehouse, heated swimming pool or
other location where temperature and humidity are significantly different. (Failure
to heed this warning may result in electrical shock or malfunctioning.)
– Do not install this product where it will be directly exposed to rain.(Failure to heed
this warning may result in electrical shock or malfunctioning.)
– Do not install this product in a location where acid, alkali or organic solvent vapors,
paints or other toxic gases, gases containing corrosive components or high
concentrations of oily smoke are present (Failure to heed this warning may result
not only in malfunctioning but also fire, power leakage and electrical shock.)
– Do not use this product outside the range of its rated voltage and control capacity.
– Install this product in an environment where the temperature ranges from 0 °C to
+40 °C and the relative humidity is less than 80%. If condensation is expected to
form, heat up the fresh outside air by a duct heater etc.
– Select an adequately sturdy position for installing the product and install it properly
and securely.
– Use the designated electrical wires for the terminal board connections and connect
the wires securely so that they will not be disconnected.(Failure to ensure proper
connections may result in fire.)
– When passing metal ducts through wooden buildings clad with metal laths, wire
laths or metal, these ducts must be installed in such a way that they will not make
electrical contact with metal laths, wire laths or metal sheets.(Power leakage can
cause ignition.)
– The outside ducts must be tilted at a gradient (1/30 or more) downwards toward
the outdoor area from the main unit, and properly insulated. (The entry of rain
water may cause power leaks, fire or damage to household property.)
– Gloves should be worn while installation. (Failure to heed this warning may result
in injury.)
– A dedicated circuit breaker must be installed at the origin of mains power supply.
This circuit breaker must be provided with a means for locking (lock and key).
– The body of the unit, room control panel and cables keep away the unit 3 m.
distance
– This product must not be disassembled under any circumstances. Only authorized
repair technicans are qualified to conduct disassembly and repairs. (Failure to
heed this warning may result in fire, electrical shock or injury.)
– Connect the product properly to the ground.(Malfunctioning or power leaks can
cause electrical shock.)
– An isolator switch having minimum contact gap of 3 mm in all poles must be
provided as a means of disconnecting the power supply.
NOTE
- The installations,which is not available for installation and operation manual, is out of guarantee.
PROHIBITED
ATTENTION
