23
STAB AND ELEVATOR ASSEMBLY
Elevator Servo Installation
1.
The elevators have been pre-hinged and
glued
to
the stabs and are ready for flight. No other steps
are necessary for hinging.
You will need the following items:
•
(2) Servos with mounting screws
•
(2) 1 1/4” Servo arms
•
(2) 36” Servo Extensions
•
(2) Aeroworks Safety Clips
Note:
36” servo extension will be used to
connect servos to receiver during a later
step.
1. Elevator servo is installed in the root end of the
elevator. We have precut a slot in the mounting
rail for the servo lead to fit into.
2. Slide servo into the opening of the stab. The
servo output shaft should face the leading edge
of the stab.
3. The servo should fit in the servo opening as
shown below, if necessary sand the opening
slightly if the servo is a tight fit.
Note:
Make sure servo lead is not binding or
crimped. This may cause the wire to be cut.