17
8. Tape leading edge of the elevator balance tab to
the leading edge of the stab in the neutral posi-
tion. Plug the elevator servo into the receiver
and turn radio on. Ensure the servo trim is cen-
tered.
9. Attach the stab and elevator to the fuse and bolt
in place. Adjust the length of the elevator push-
rod so that the servo arm is 90 degrees to the
servo case when it is placed on the servo output
shaft. Ensure the servo does not bind at either
end point at full deflection.
10. Repeat the above steps for the other stab and
elevator.
11. Finished elevator servo installation shown be-
low.