Aerotech A3200 Series, Руководство по оборудованию

Страница: 77 / 132

Installation and Configuration Npaq® Hardware Manual
2.10.2. Analog Inputs (J10)
To interface to a single-ended (non-differential) voltage source, connect the signal common of the source to
the negative input and the analog source signal to the positive input. A floating signal source should be
referenced to the analog common as shown in
Figure 2-41 .
Table 2-43: Differential Analog Input 1 Specifications (J10)
Specification Value
(AI+) - (AI-)
+10 V to -10 V
(1)
Resolution (bits) 16 bits
Resolution (volts) 305 µV
1. Signals outside of this range may damage the input
Table 2-44: Analog Input Pins on the Analog I/O Connector (J10)
Pin # Description In/Out/Bi
1 Analog Input 0+ Input
2 Analog Input 1+ Input
3 Analog Input 2+ Input
4 Analog Input 3+ Input
7 Analog Ground N/A
8 Analog Ground N/A
9 Analog Input 0- Input
10 Analog Input 1- Input
11 Analog Input 2- Input
12 Analog Input 3- Input
15 Analog Ground N/A
Figure 2-41: Analog Inputs (J10)
www.aerotech.com Chapter 2 77