Aerotech A3200 Series, Руководство по оборудованию

Страница: 75 / 132

Installation and Configuration Npaq® Hardware Manual
2.10. Analog I/O Connector (J10)
The Analog I/O Connector (J10) is a 15-pin ‘D’ style connector located on the Rear Panel Interface board and
is accessible at the rear of the Npaq chassis. The Analog I/O interface provides the user with four differential
16-bit analog inputs and two single-ended 16-bit analog outputs.
Table 2-41 provides the specifications for
the analog outputs.
Table 2-39: Analog I/O Connector Pinout (J10)
Pin # Description In/Out/Bi Connector
1 Analog Input 0+ Input
2 Analog Input 1+ Input
3 Analog Input 2+ Input
4 Analog Input 3+ Input
5* +5 Volts Output
6 Analog Output 0 Output
7 Analog Ground N/A
8 Analog Ground N/A
9 Analog Input 0- Input
10 Analog Input 1- Input
11 Analog Input 2- Input
12 Analog Input 3- Input
13 Not Used N/A
14 Analog Output 1 Output
15 Analog Ground N/A
* Pin 5 is unused on Npaq's produced before February 2009.
Table 2-40: Mating Connector Part Numbers for the Analog I/O Connector (J10)
Mating Connector Aerotech P/N Third Party P/N
15-Pin D-Connector ECK00100 Amphenol DA15P064TXLF
Backshell ECK01022 Amphenol 17E-1725-2
N O T E : Analog inputs 2 and 3 are required for Joystick operation. They will not be otherwise accessible if
a joystick option is present (see Section 2.11. ). If a joystick option is present, AIN2 and AIN3 must be
jumper configured (see Table 4-8 ) as single ended inputs.
www.aerotech.com Chapter 2 75