Angle Finish Nailer DA64R Http://www.aeroprotools.com
4
In add
i�
on, fastener driving tool is
fi�e
d with a safety yoke which enables the driving opera
�
on to be carried out only
a�er
the safety
yoke of the tool is pressed against a work piece, These tools are marked with an inverted triangle
▽
behind the serial number and are
not permi
�
ed for use without an e
ff
ec
�
ve safety yoke. A safety yoke is not required on fastener driving tools which accelerate the
heaviest usable fasteners to a free
fli
ght velocity below an admissible risk of injury. Those fastener driving tools are not marked with an
inverted triangle.
SAFETY INSTRUCTIONS FOR COMPRESSED AIR SYSTEM
Proper fun
c�
oning of the fastener driving tool requires
filt
ered, dry and lubricated compressed air in adequate quan
��
es.
If the air pressure in the line system exceeds the maximum allowable pressure of the fastener driving tool, a pressure reducing
valve followed by a downstream safety valve shall add
i�
onally be
fi�e
d in the supply line to the tool.
The compressor plant shall be adequately dimensioned in terms of pressure output and performance(volumetric
fl
ow) for the
consump
�
on which is to be expected. Line se
c�
ons which are too small in rela
�o
n to the length of the line(pipes and hoses), as
well as overloading the compressor, will result in pressure drops.
Permanently laid compressed air pipelines should have an internal diameter of at least 19 mm and a corresponding large diameter
where rela
�
vely long pipelines or mu
l�
ple users are involved.
Compressed air pipelines should be laid so as to form a gradient (highest point in the dire
c�
on to the compressor ). Easily
accessible water separators should be installed at the lowest points.
Jun
c�
ons for users should be joined to the pipelines from above,
Conne
c�
ng points for fastener driving tools should be
fi�
ed with a compressed air servicing unit (
filt
er/water separator/oiler)
directly at the jun
c�
on point.
RESIDUAL RISKS
Even if you are opera
�
ng this product in accordance with all the safety requirements, poten
�
al risks of injury and damage remain. The
following dangers can arise in conne
c�
on with the structure and design of this product:
1. Health defects resu
l�
ng from vibra
�
on and noise emission if the product is being used over long periods of
�
me or not adequately
managed and properly maintained.
2. Injuries and damage to property due to fasteners or the sudden impact of hidden objects during use.
3. Danger of injury and property damage caused by
fl
ying objects.
FASTENER
TOOL
Nail type
Magazine capacity
100pcs
Air inlet size
1/4”(6.35mm)
Air hose size
3/8”(9.52mm)
Max working pressure
120PSI(8.3bar)
Working pressure range
80-120PSI(5.5-8.3bar)
Exhaust
Rear adjustable(360
°
)
Tool weight(no nails)
2.09kg(4.6lb)
SYMBOLS
SPECIFICATIONS