Aeropro CZ A220, Руководство по обслуживанию

Страница: 7 / 158

Maintenance Manual
AEROPRO CZ 1-2
Maintenance Manual
March 21, 2020
Figure 1-1.
Gross weight........................................................................... 1235 lb
Fuel capacity........................................................................... 22 gal.
Oil capacity.............................................................................. 0.79 gal.
Engine model (Refer to Section 11 for E
ngine Data)….......... .Rotax 912 ULS
Propeller.................................................................................. 3-blade
Ma
in wheel tires………………………………………........…… 15x6.00x6 (standard tires)
Pressure……………………………………………....... 29 psi (standard tires)
No
se wheel tire…………………………………………….......... 12x4
Pressure……………………………………………....… 29 psi
Aileron travel Up....................................................................... 18°, +/- 2°
Down............................................................................ 8.5°, +/- 1°
Wing flap travel......................................................................... 0° to 20°, +/- 2°
Rudder travel Right................................................................... 27°, +/- 2°
Left............................................................................... .27°, +/- 2°
Elevator travel Up..................................................................... 35°, +/- 2°
Down................................................................... 27°, +/- 2°
Elevator trim tab travel Up.......................................................... 15°, +/- 3°
Down...................................................... 50°, +/- 3°
Principal dimensions
Wing span....................................................................... 29.9'
Length with prop spinner................................................. 18.5'
Vertical stabilizer height.................................................. 7.3'
Track width...................................................................... 4.5'
Tail span.......................................................................... 7.8'
Battery location................................................................ under right seat
1.4 Torque values
A chart of recommended nut torque values is shown in figure 1-2. These torque values are
recommended for all installation procedures contained in this manual, except where other values are
stated. They are not to be used for checking tightness of installed parts during service.
Figure 1-2.
M4……………………………………………………………. 4 Nm / 35 in.lb.
M5……………………………………………………………. 6 Nm / 53 in.lb.
M6……………………………………………………………. 10 Nm / 88 in.lb.
M8……………………………………………………………. 24 Nm / 212 in.lb.
M10…………………………………………………………... 35 Nm / 310 in.lb.
1.5 Tire inflation pressure
Maintain tire pressure at the air pressures specified in figure 1-1. When checking the tire
pressure, examine the tires for wear, cuts, bruises and leakage. Remove oil, grease and mud from
the tires with soap and water.
1.6 Approved oils and capacities
In general we recommend referring to the latest Rotax 912-series engine operators manual
to check for a suitable engine oil. In the United States, only Aeroshell Sport 4 oil is recommended.
1.7 Equipment list
In figure 1-5 a list of the factory installed equipment is provided. Additionally installed
equipment and alterations have to be considered when performing the weight and balance
calculation. If a ballistic recovery system is installed from the factory, this is already included in the
factory weight and balance calculation form.