6
SAFETY INSTRUCTIONS….cont
CAUTION:
The warnings and cautions mentioned in this user manual can not
cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which can-
not be built into this product, but must be applied.
We recommend wearing ear protection - particularly during extended
periods of operation.
We recommend wearing a face mask or respiratory equipment when
using any air tool; particularly during drilling, sanding, grinding, sawing or
other operations likely to cause airborne particles.
Always wear approved safety goggles / glasses when using or maintain-
ing any air tool, everyday eyeglasses have only impact resistant lenses,
they are not safety glasses.
Note:
If any of the above are missing or damaged, contact your distributor
immediately.
Dual Action Sander
Instruction Manual
Quick Coupler (Euro type)
Sanding Pad
Small Bottle of Oil
CONTENTS AND ACCESSORIES
11
DO NOT
use the tool if it is, or has parts that are worn, damaged or missing; re-
move from service and have the parts repaired / replaced using original spare
parts.
Ensure that the air tool is lubricated daily with a few drops of air tool oil dripped
into the air inlet.
Clean the air tool after each use.
Check hose and fittings for wear or damage before each use.
Drain the air tank / receiver of the compressor daily; Water in the air line will
damage the sander
In the event that it becomes necessary to store the tool for an extended period
of time (overnight, weekend, etc.), it should receive a generous amount of lubri-
cation at that time. The tool should be run for approximately 30 seconds to en-
sure oil has been evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
Disconnect the air tool from the air supply before changing accessories,
servicing or performing maintenance. Replace or repair damaged parts.
Use genuine parts only. Non-authorised parts may be dangerous and will
invalidate the warranty.
OPERATING THE SANDER
Once the sanding pad is fitted and secure:
Connect the drill to the air supply via the air inlet (5).
Use the built in air regulator (3) to set the correct airflow.
Press the air trigger (6) and the sander will operate.
Release the air trigger (6) and the sander will stop.
Note:
Never start the sander with the disc touching the work-piece. Allow
the sander to reach full speed before starting the sanding operation.
OPERATING INSTRUCTIONS….cont
MAINTENANCE