Serial Number: 1203
30
5.15 Landing
Speed
90–100kmph
Flaps
30° position
Trim
As necessary
At approx. 5m height above runway, start pulling the yoke to reduce descent rate; at
approx. 0.5m above runway, let the plane to loose speed gradually, until the touch down.
Always touch down on main landing gear wheels.
Pull up yoke gradually to maintain nose gear above ground for as long as possible.
When nose gear finally touches down, apply brakes as necessary.
If runway is short or clearway is high, extend the flaps to 40°. With the flaps in this
position, descend rate increases markedly. Maintain speed 90km/h.
5.16 Go-around
Throttle
Full engine power (5700rpm max.)
Flaps
Retract to “take-off” position
Start climbing
Speed at least 100km/h IAS
Trim
As necessary
Adjust speed for
120kmph IAS
climbing
Flaps
Retract, min. height above ground 150ft
Trim
As necessary
Go around
5.17 Actions after landing
Flaps
Retract
Trim
Middle position
Engine rpm
As necessary
Observe taxiing rules Speed up to 10kmph
5.18 Stopping the engine
Engine rpm
Idle
Instruments
Engine instrument needles within limits
Avionics
Switch off
Ignition
Switch off
Section switches
Switch off
Main switch
Switch off
Fuel cocks
Close
